Treatment for surface mould in Nicosia

For surface growth that has not rooted into the plaster, the kind that appears each winter on cold external walls, around window frames and in the ceiling corners of older Nicosia flats. We kill it and seal the surface, usually in one visit with no building work, and show you what fed it. Mould that has gone deeper, is spreading or keeps coming back needs removal instead.

Surface mould treatment from €125. Quote reply within 12 hours. Pay by cash or card on site.

Not sure how bad it is?Send a few photos and a specialist replies with a price within 12 hours.
Get a free quote

What is included

Treatment suits small patches on sealed or non-porous surfaces. If the readings show the mould has gone deeper, we tell you before starting and quote removal instead.

Surface check

Moisture readings confirm the growth is on the surface and not feeding from damp inside the wall.

Anti-microbial treatment

The affected surfaces are treated to kill the growth and the spores around it.

Sealing

Treated areas are sealed to make it harder for mould to settle again.

Humidity advice

We show you what fed the growth, such as cooking steam, drying laundry indoors or a blocked vent, and what to change.

Which Nicosia patches stay on the surface

Plenty of the mould people find in the capital has not had time to dig in. It is the grey bloom that appears on a window reveal in the first cold weeks, the black specks along shower grout, the fur on the back of a chest of drawers that stood against an outside wall all winter. If the surface underneath is sound and the growth wipes to a stain rather than a hole, it is usually a case for surface treatment, from €125, normally carried out in one visit with no building work.

Tiled bathrooms are a good example. Mould on grout lines and tiled walls and on the paint just above the tiles is often surface-deep, even when it looks heavy.

Habits that feed it in a Nicosia winter

Inland winters bring a run of grey, wet days, and households respond in ways that put water into the air:

  • Laundry dried on racks in the living room or a spare bedroom, because outside it will not dry. The effect is bigger than most people expect; see what indoor drying does to a room.
  • Portable gas or paraffin heaters, which release moisture as they burn.
  • Windows kept shut day and night to hold the heat in.
  • Showers with the door closed and no extractor running, leaving steam to settle on the ceiling.

None of these is unusual, and changing one or two often does more than any product. Treatment clears the growth that is there; the report shows what fed it.

When treatment will not be enough

Some Nicosia cases look minor but are not. A patch that has come back after being treated before, plaster that sounds hollow when tapped, a bathroom ceiling that peels in strips (our article on a bathroom ceiling that keeps going black covers this) or growth that has spread across a whole wall all point to removal from €175 instead. So does mould that lines up with a crack, a pipe or a roof edge, because that suggests water from outside rather than condensation from inside. If the photos you send show any of this, the specialist who prices the job will say so before anything is booked.

Keeping a treated wall clean

A treated surface stays clear when the room gets drier. That often means a better extractor, a gap between furniture and the outside wall, or insulating the one cold spot that keeps attracting moisture.

How it works

  1. Tell us

    Send photos or book a visit. It takes two minutes.

  2. We measure

    A specialist maps the moisture and finds the cause.

  3. We fix it

    Mould removed, source repaired, surface protected.

  4. It stays gone

    Optional monthly checks catch regrowth early.

Common questions

When is treatment enough vs. removal?
Treatment suits surface growth on sealed or non-porous materials. If mould has rooted into plaster or spread widely, removal is needed — we confirm which on inspection.
Is the treatment safe to stay in the home?
You will need to keep the treated room ventilated and avoid it for a short period; we brief you fully on the day.
Can treatment deal with mould caused by my paraffin heater?
It can clear the surface growth the heater helped to cause, but the moisture will keep coming while the heater runs in a closed room. Airing the room for a while each day, or switching to a heat source that does not burn fuel indoors, is what stops the patch reforming.
Is the black mould on my shower grout a surface problem?
In most Nicosia bathrooms, yes. Grout and the paint above the tiles usually carry mould on the surface, which treatment handles. If the grout has crumbled, tiles have loosened or the wall behind feels damp, water may be getting through, and that needs a closer look first.

Keep reading

Send photos today. Know the price by tomorrow.

Free quote within 12 hours, or book an inspection from €75.

CallGet a free quote